Auto Cutter Specifications; Interface; Ac Adapter (Option) - Star TSP800II SERIES Hardware Manual

9-2. Auto Cutter Specifications

(1) Cutting frequency
(2) Thickness of paper

9-3. Interface

RS-232C serial interface / Two-way parallel interface (IEEE1284) / USB interface / Ethernet
interface

9-4. AC Adapter (Option)

(1) Operating Voltage
(2) Current Consumption (DC 24 V at room temperature)
Standby:
ASCII printing:
100% print duty:
(3) Power Connector
Pin No.
1 Drive power (24 V)
2
3
Shell Frame ground
Note:
• When using a printer power supply other than the optional AC adaptor (PS60A-24 series),
be sure that the following cautions are observed.
• Use a power supply of DC 24 V ± 5% and more than 2.0 A (5.0 A Load 10 sec. Max.)
with SELV output and LPS or Class 2 output approved by IEC60950-1.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
Max. 20 cuts per minute
0.065 ~ 0.15 mm (when using 115.5 mm width paper)
0.065 ~ 0.085 mm (when using 79.5 mm width paper)
Input Voltage: 90 to 264 V AC, 50/60 Hz
Output Voltage: DC 24 V±10%
(Approx. 17.5% printing rate)
(Solid printing):
(Continuous solid printing should be 50 mm or less.)
Function
Signal GND
N.C.
Approx. 0.12 A
Approx. average 2.0 A
Approx. peak 8.6 A
Approx. average 4.2 A
1
2
<Viewed from Connector Surface>
– 32 –
3