Starting The High Pressure Washer; Pressure Regulation On The Tornado® Pr- Nozzle; Stationary Use - Nilfisk-Advance E 130.3 User Manual


When connecting the machine to operate from pressure less water supplies – always use ad-
ditional fi ltering to secure that impurities are not sucked in. Hose length should be max. 3 meter
and of minimum ½".
To meet these requirements, Nilfi sk recommends that you use the original Nilfi sk suction hose
kit.
The Machine is designed for suction up to 100 cm above water surface.
• Position the machine at max. 1.0 meter above the water surface. Detach the high pressure
hose from the outlet.
• Ensure that the inlet fi lter is in position and attach the suction hose kit, secure tight connec-
tion to the inlet.
• Turn on the machine, turning the start/stop switch (1) to position "I".
• Wait until a steady jet exits the outlet.
• Switch off the machine and attach high pressure hose (4), spray handle, lance and nozzle.
• Start the machine again and activate the spray handle.

4.4 Starting the high pressure washer


Connecting to mains power supply
The voltage and frequency of the machine (see model tag (13)) must match the voltage and
frequency of the power supply.
Connecting the high pressure washer to a supply system, the max allowed impedance is =
0,29+j0,18 (Zmax). Consult with the supply authority that the equipment is connected only to
a supply of that impedance or less.
Insert the power plug into power supply socket.
B9

Turn on the water.
B10
Release the trigger lock (7a). Remember to unplug, turn off the high pressure washer and
B11
lock the trigger, when leaving the high pressure washer unattended
Activate the trigger of the spray handle and let the water run until all air has escaped from
B12
the water hose.
Turn on the machine, turning the start/stop switch to position "I".
B13
Activate the trigger of the spray handle. When releasing the trigger of the spray handle,
B14
the machine automatically stops. The machine will start again when you reactivate the
trigger of the spray handle.
4.5 Pressure regulation on the TORNADO® PR- nozzle
The pressure can be regulated on the TORNADO
B15

4.6 Stationary use

If mounting a special wall hook (not standard), the pressure washer can be used as a
B16
stationary solution meaning that it can be operated while hanging on the wall.
Only mount the wall hook on a sturdy wall. Adjust the length of the screws and size of
rawlplugs to the type of wall.
On the wall hook garden/rim brush (a) foam sprayer (b), Click & Clean brush (c) and Click
B17
& Clean nozzles (d) can be stored.

The bearing capacity of the wall hook is max. 30 kg.
Original Instructions
IMPORTANT!
®
PR nozzle.
IMPORTANT!
EN
DA
NO
SV
FI
DE
FR
NL
IT
ES
PT
EL
TR
CS
HU
PL
HR
SL
SK
LV
LT
ET
RU
ZH
13