Gold's Gym Preview 1000 User Manual page 9

If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the key is removed from the con-
sole and that the power cord is unplugged.
Remove the indicated Screws (3) from the back of the
Console Base (85).
2. Connect the wire on the receiver (A) to the indicated
wire on the Console (34). Hold the receiver so the
small cylinder is oriented as shown. Next, remove
the tape from the back of the receiver, and press the
receiver onto the Console Base (85) in the location
shown.
3. Make sure that no wires are pinched. Reattach the
Console (34) with the Screws (3). Discard the other
wires included with the receiver.
Small Cylinder
34
Wire
3
3
9
A
85
3
3