4.4.2
RX300 S6 CG to the direct current
4.4.2.1
Connecting the power cord
Figure 18: Connecting the server to the dc voltage
Ê Connect the power cable with connector to the power supply unit of the
server (1).
Ê Attach the connector with the 2 screws (2)
Ê Connect the wire labeled "Ground" to an appropriate earth ground.
Ê Connect the other two wires of the po wer cable to the current bar on the rac k
(see Technical Manual of the rack).
RX300 S6
Connecting the server to the power source
Operating manual
65