Fujitsu PRIMERGY RX300 S6 Operating Manual page 58

Installing/removing the server in/from the rack
Racks with installation depth of 735 mm
The lengths of the telescopic rails do not need to be adjusted with respect to
each other for the installation in rack systems with 735 mm installation depth.
Ê Secure the support systems as described in section
systems" on page
Ê Mount the server (see
cables as described in the original manual of the rack.
V
CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see
Racks with installation depth smaller/greater than 735 mm
The support systems can be used for installation depths of 714 - 785 mm. The
spring element of the support system is used to adjust the length as required.
Ê Secure the support systems as described in
on page 53.
Ê Mount the server (see
cables as described in the original manual of the rack.
V
CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see
58
53.
"Inserting the server" on page
figure 9 on page
"Inserting the server" on page
figure 9 on page
Operating manual
"Installing the support
56) and route the
53).
"Installing the support systems"
56) and route the
53).
RX 300 S6