Replacing A Memory Module; Removing The Air Duct - Fujitsu PRIMERGY RX300 S6 Operating Manual

Non-hot-plug components
8.2.1

Replacing a memory module

Ê Remove the housing cover (see
page 119).
The slots for the memory modules can be found under the air duct.
8.2.1.1

Removing the air duct

Figure 36: Removing the air duct
I
If you have installed an SAS/SATA RAID controller with a BBU: pay
attention to the BBU cable when lifting off the air duct! If you want to
remove the air duct from the server completely, first disconnect the BBU
cable.
Ê Take hold of the air duct by the green touch points, and lift it up and off.
114
section "Opening/closing the housing" on
Operating manual
RX 300 S6