Table of Contents
Advertisement
10 en |
The EX80/82IP needs to be powered-up while making the LED power
adjustments. Cover the photocell to turn the LEDs "ON" (850nm
LEDs will have a slight red glow). Adjust the LED power if they are
too bright or too dim. For IR power adjustment, rotate VR1. Clockwise
is high and counter-clockwise is low
2.9
Photocell Adjustment
The photocell is factory set optimum level. In some conditions such
as with bright foreground objects the camera may switch too early or
too late. For photocell "On/Off" light-level adjustment, rotate IR
Adjustment Pot. Clockwise is off and counter-clockwise is on.
Re-assemble the IP board into the chassis and carefully attach the
rear cover.
2.10
Camera re-assembly
Make sure all wires are properly connected, all holes are sealed
against moisture penetration, and all mounting screws are tight.
1.) Position the photocell properly in the small hole of the window
foam.
2.) Slide the lens foam over the camera lens. Make sure the foam is
snug and as close to the faceplate viewing window as possible
and the photocell is secure with an unobstructed view.
3.) Attach the window, faceplate, and the rear cover to the camera
housing. Tighten the four bolts.
4.) Tighten the camera's adjustable mounting bracket after the
desired viewing angle has been determined.
5.) Power-up the camera and check its operation.
MAN80/82IPB Rev.0 | 2008.10
Quick Install
EX80/82-IP
Bosch Security Systems
Advertisement
Table of Contents
