Camera Re-Assembly - Bosch Infrared Imager Ex80 Installation Instructions Manual

7. CAMERA RE-ASSEMBLY

Make sure all wires are properly connected, all holes are
sealed against moisture penetration, and all mounting
screws are tight.
•
Slide the lens foam over the camera lenses. Make
sure the foam is snug and as close to the faceplate
viewing window as possible and the photocell is
secure with an unobstructed view.
•
Attach the window, faceplate, and the rear cover to
the camera housing. Tighten the four bolts.
•
Tighten the camera's adjustable mounting bracket
after the desired viewing angle has been determined.
•
Power-up the camera and check its operation
.