Operating-Mode (S2) - Fujitsu FLASH-CAN-64P-350-PMC User Manual

4.2 Operating-Mode (S2)

The DIP-switch S2 is used to set the operating mode of the IC.
Ensure that the mode pin settings correspond to the operation-mode of the application.
For more detailed information please check the Hardware-Manual of the microcontroller.
DIP switch
S2/1 (MD0)
S2/2 (MD1)
S2/3 (MD2)
S2/7 (P01)
S2/8 (P00)
Default: MD0, 1, 2 = 1 1 0 P00, P01 = 0 0
By default, the Single Chip Run-Mode is selected.
Dip-Switch S2
(default setting)
UG-960008-10
FLASH-CAN-64P-350-PMC
Chapter 4 Jumpers and Switches
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
S2/4
S2/5
S2/6
ON (closed)
OFF (open)
ON (closed)
OFF (open)
MD0 MD1 MD2 nc
1 2 3
Setting Logical value
not connected (OFF)
not connected (OFF)
not connected (OFF)
nc nc P01 P00
4 5 6 7
- 10 - © Fujitsu Microelectronics Europe GmbH
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
1 (high)
0 (low)
1 (high)
0 (low)
ON
OFF
8