Jumpers And Switches; Operating Mode (S1) - Fujitsu SK-96380-120PMT User Manual

3 Jumpers and Switches

This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting for the MB96F387 Series is shown with a grey shaded area.

3.1 Operating Mode (S1)

This switch controls the MCU operation mode after Reset.
Please take care of the following mode settings:
DIP switch
S1/1 (MD0)
S1/2 (MD1)
S1/3 (MD2)
S1/4 (Not used)
DIP-Switch S1
(default setting)
Figure 3-1: MCU mode switch: Fixed Vector Mode
DIP-Switch S1
Figure 3-2: MCU mode switch: Flash Programming Mode
© Fujitsu Microelectronics Europe GmbH
SK-96380-120PMT User Guide
Chapter 3 Jumpers and Switches
Setting
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
Table 3-1: MCU Operating Mode
MD0 MD1 MD2 nc
ON
OFF
1 2 3 4
MD0 MD1 MD2 nc
ON
OFF
1 2 3 4
- 15 -
Logical value
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
Not connected
Not connected
FMEMCU-UG-960001-15