Table of Contents
Advertisement
Onboard LAN device
Enabled
Disabled
Init Display First
AGP
8PCI
C Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard Serial Port 2
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
UART Mode Select
(This item allows you to determine which Infra Red(IR) function of Onboard I/O chip)
ASKIR
IrDA
Normal
UR2 Duplex Mode
Half
Full
GA-8ST Motherboard
This Manual: http://www.manuallib.com/file/2597476
Realtek LAN is enabled. (Default value)
Realtek LAN is disabled.
Set Init Display First to AGP. (Default value)
Set Display Init First to PCI.
BIOS will automatically setup the port 1 address.
Enable onboard Serial port 1 and address is 3F8. (Default value)
Enable onboard Serial port 1 and address is 2F8.
Enable onboard Serial port 1 and address is 3E8.
Enable onboard Serial port 1 and address is 2E8.
Disable onboard Serial port 1.
BIOS will automatically setup the port 2 address.
Enable onboard Serial port 2 and address is 3F8.
Enable onboard Serial port 2 and address is 2F8. (Default value)
Enable onboard Serial port 2 and address is 3E8.
Enable onboard Serial port 2 and address is 2E8.
Disable onboard Serial port 2.
Set onboard I/O chip UART to ASKIR Mode.
Set onboard I/O chip UART to IrDA Mode.
Set onboard I/O chip UART to Normal Mode. (Default Value)
IR Function Duplex Half. (Default Value)
IR Function Duplex Full.
- 32 -
Advertisement
Table of Contents
