Table of Contents
Advertisement
5.2 Synchronous Mode
In order to program the Flash-ROM synchronously via Serial I/O (SCI3) special software has
to be used, e.g. Galep-4 from Conitec with a serial adapter. This tool is not available free.
Please contact the following Web Site in order to get more information:
A dedicated Flash programming socket (X17) is provided on the evaluation-board for direct
connection to the serial adapter of GalepIV.
X17: Flash programming socket
In case that the Galep-4 with serial adapter is used, all Mode-settings will be done
automatically by the Galep-4. This means that all DIP-switch S2 has to be set to the "OFF"
position.
When using
Conitec's Galep-4
Please refer to the manual of Conitec's Galep-4 for more information how to program a
Flash-device by the synchronous-serial mode.
Note:
In case that another Programming-Tool is used and the Mode-settings have to be done
manually then use the following configuration of DIP-switch S2 in order to select the
synchronous-serial Flash-programming mode:
synchronous
Boot-Mode
© Fujitsu Microelectronics Europe GmbH
FLASH-CAN-64P-350-PMC
Chapter 5 Programming the internal Flash
P00 1
MD0 3
RST 5
SOT3 7
VCC 9
MD0 MD1 MD2 nc
1
2
3
MD0 MD1 MD2 nc
1
2
3
- 21 -
2 P01
4 MD2
6 SIN3
8 SCK3
10 GND
nc
nc
P01 P00
4
5
6
7
8
nc
nc
P01 P00
4
5
6
7
8
http://www.conitec.de
ON
OFF
ON
OFF
UG-960008-10
Advertisement
Table of Contents
