Can"A" (Jp: 25, 26); Can"B" (Jp: 27, 28) - Fujitsu FLASH-CAN-64P-350-PMC User Manual

4.10 CAN"A" (JP: 25, 26)

One high-speed CAN-transceiver can be connected to CAN1.
JP25, JP26 connects the CAN1-Port to the CAN-transceiver (U7, X10).
If the CAN interface is not used, the jumpers should be left open.
Jumper Setting
Open
JP25 (TX1)
Closed
Open
JP26 (RX1)
Closed
Default: JP25=closed, JP26=closed
By default, the CAN"A"-transceiver is connected to CAN1 of the microcontroller

4.11 CAN"B" (JP: 27, 28)

For the MB96350 Series one high-speed CAN-transceiver can be connected to CAN2.
JP27, JP28 connects the CAN2-Port to the CAN-transceiver (U8, X11).
Using CAN2 will disconnect LED D3 and D4.
Jumper Setting
JP27 (TX2)
JP28 (RX2)
Default: JP27=1-2, JP28=1-2
By default, LED D3 and D4 are connected to Port P32 and P33 of the microcontroller.
UG-960008-10
FLASH-CAN-64P-350-PMC
Chapter 4 Jumpers and Switches
Description
TX1 is disconnected from CAN-Transceiver (U7, X10)
TX1 is connected to CAN-Transceiver (U7, X10)
RX1 is disconnected from CAN-Transceiver (U7, X10)
RX1 is connected to CAN-Transceiver (U7, X10)
Description
1-2 Pin 57 (P33) is connected to LED D4
2-3 TX2 is connected to CAN-Transceiver (U8, X11)
1-2 Pin 56 (P32) is connected to LED D3
2-3 RX2 is connected to CAN-Transceiver (U8, X11)
- 16 - © Fujitsu Microelectronics Europe GmbH