Table of Contents
Advertisement
T
E
ENSIONING AN
XISTING
1. Enter the MANUAL workout and operate the treadmill for five minutes at 5.0 mph (8.0 kph).
Note: DO NOT RUN OR WALK ON BELT.
2. Reduce the speed to 2.0 mph (3.2 kph). Walk on the treadmill. Tightly grip the handrails and apply force with feet on
the striding belt near the motor cover against the moving belt direction. If the belt slips, continue to Step 3. If it does
not slip, the tension is correct.
3. Using the STOP key, stop the treadmill. Turn the belt tensioning bolts a quarter-turn clockwise for each side.
4. Repeat STEPS 2 and 3 until the belt no longer slips. Do not exceed one full turn (four quarter turns) per side when ad-
justing the belt tensioning bolts.
5. Enter the MANUAL workout, and operate the treadmill at 2.0 mph (3.2 kph) and check to insure proper tracking. If the
striding belt drifts to the left or right see Tracking (Centering) A Striding Belt on the previous page.
Do not overtighten the tensioning bolts while making belt adjustments. Overtightening of bolts may over stretch and dam-
age the striding belt or roller bearings. Do not exceed one full turn of either bolt in either direction.
U
T
SING AND
ESTING THE
During operation of the treadmill, the lanyard on the Safety Stop Pull Cord should be attached to an item of the user's
clothing.
While the treadmill is on and the console display is active, remove the Safety Stop Pull Cord from the treadmill. A mes-
sage shall be displayed on the console similar to "REPLACE EMERGENCY STOP SWITCH". With the Safety Stop Pull
Cord removed no keys shall function on the treadmill.
Place the Safety Stop Pull Cord back in place. The treadmill will reset and will be ready for operation.
P
B
W
ROACTIVE
ELT
The treadmill proactively notifies the facility manager about belt wear through diagnostics. A single indicator is lit on the
treadmill console (if manager-enabled) when a belt check is required. This indicator light is located in the upper left corner
of the workout profile window.
T
O CHECK FOR NOTIFICATIONS
To enter Belt/Deck Info, press the CLEAR key twice and then quickly press and hold the PAUSE key until the MESSAGE
CENTER displays the words "SERVICE MENU". Use any of the UP/DOWN arrow keys to navigate to the INFORMATION
Menu. Then access the "Belt / Deck Information" submenu.
Note: Notifications are automatically cleared once they have been displayed.
S
B
TRIDING
ELT
S
S
AFETY
TOP
N
EAR
OTIFICATION
:
P
C
ULL
ORD
13
Hide quick links:
Advertisement
Table of Contents
