Support - Sapido RB-1842 User Manual

A: The Wireless Router processes the data passing through it, so it is not transparent.
Use the Special Application feature to allow the use of Internet applications which do
not function correctly. If this does solve the problem, you can use the DMZ function.
This should work with almost every application, but:
It is a security risk, since the firewall is disabled.
Only one (1) PC can use this feature.
5. Q: I can't connect to the Wireless Router to configure it.
A: Check the following:
The Wireless Router is properly installed, LAN connections are OK, and it is
powered ON.
Make sure that your PC and the Wireless Router are on the same network
segment.
If your PC is set to "Obtain an IP Address automatically" (DHCP client), restart it.
If your PC uses a Fixed (Static) IP address, make sure that it is using an IP
Address within the range 192.168.1.129 to 192.168.1.253 and thus compatible
with the Wireless Router's default IP Address of 192.168.1.254. Also, the
Network Mask should be set to 255.255.255.0 to match the Wireless Router. In
Windows, you can check these settings by using Control Panel ~ Network to
check the Properties for the TCP/IP protocol.
6. Q: The WinXP wireless interface couldn't communicate the WEP with RB-1842's
wireless interface.
A: The default WEP of WinXP is Authentication Open System - WEP, but the WEP of
RB-1842 is only for Shared Key - WEP, it caused both sides couldn't communicate.
Please select the WEP of WinXP from Authentication Open System to Pre-shared
Key - WEP, and then the WEP wireless interface between WinXP and RB-1842
would be communicated.
8.7

Support

1. Q: Why can't the NTFS hard disk be used with RB-1842?
A: RB-1842 doesn't support the NTFS hard disk. It only supports EXT3 and FAT32 file
systems.
2. Q: Why can't my USB devices work on RB-1842?
http://www.sapido.com.tw
93 User Manual 1.0