Setting The Top-Of-Form; Moving The Bail; Parking The Paper; Clearing The Buffer - AMT Datasouth AMTACCEL-5350 User Manual

Alt
Set Top
Bail
Paper
Park
Clear

Setting the Top-of-Form

Pressing the Set Top of form button sets the top-of-form at the current
print line. When you set a top-of-form, the printer recognizes the current
print line as the first line on the page (line 0) and starts counting lines
from that point.

Moving the Bail

Pressing the Bail button moves the bail back and forth. During normal
printing operations, it is not necessary to use the Bail button since the
bail moves automatically.

Parking the Paper

Pressing the Paper Park button with pin-feed paper loaded in the printer
causes the paper to reverse-feed until the top edge of the first sheet is
halfway through the tractors. Before pressing the Paper Park button,
however, tear off the last printed sheet that has fed beyond the tear bar.
With paper park, removing pin-feed paper from the printer is quick and
easy. To reload paper, just press Form Feed.

Clearing the Buffer

Pressing the Clear button causes one of the following actions to occur:
If an error or warning message is displayed, the normal status
message reappears.
If the normal status message is displayed, the printer erases all data
that has been received but not yet printed. Since the printer receives
incoming data faster than it can print it, the printer temporarily stores
data in a buffer in memory. If you turn printing off or an error occurs,
you can erase all of the data in the buffer waiting to be printed.
Clearing the buffer does not reset any printing parameters; all of the
current settings remain in effect.
User's Guide
Control Panel 4-7