Care And Maintenance - Procom PCSD25T Owner's Operation And Installation Manual

Vent-free gas stove

Hide thumbs Also See for PCSD25T:

User manual (30 pages)

Table Of Contents

Table of Contents

Figure 28 shows a correct burner flame pattern. Figure 29 shows an incorrect burner flame

pattern. If burner flame pattern is incorrect as shown in Figure 29:

• turn heater off (see To Turn Off Gas to Appliance, page 19 or 20).

• see Troubleshooting pages 26 through 28.

Approx. 3"-6" Above Top of Logs

Figure 28 - Correct Burner Flame Pattern

More Than 8" Above Top of Logs

Air is drawn into the burner through the holes in the fitting at the entrance to the burner. These

holes may become blocked with dust or lint. Periodically inspect these holes for any blockage

and clean as necessary. Blocked air holes will create soot.

WARNING: Turn off heater and let cool before servicing.

CAUTION: You must keep control areas, burner, and circulating

air passageways of heater clean. Inspect these areas of heater before

each use. Have heater inspected yearly by a qualified service techni-

cian. Heater may need more frequent cleaning due to excessive lint

from carpeting, bedding material, pet hair, etc.

WARNING: Failure to keep the primary air opening(s) of the

burner(s) clean may result in sooting and property damage.

Periodically inspect all burner flame holes with

the heater running. All slotted burner flame

holes should be open with yellow flame pres-

ent. All round burner flame holes should be

open with a small blue flame present. Some

INSPECTING BURNERS

BURNER FLAME PATTERN

BURNER PRIMARY AIR HOLES