Installing Logs - Procom PCSD25T Owner's Operation And Installation Manual

Vent-free gas stove
Hide thumbs Also See for PCSD25T:
Table of Contents

Advertisement

WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation,
and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to high, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the
logs exactly as instructed. Do
not modify logs. Use only logs
supplied with heater. Each log
is marked with a number. This
number will help you to identify
the logs when installing. Do not
place any decorative cinders on
logs or burner.
1. Remove nylon ties connecting the pack-
ing material to the logs. The log number
is marked on the back of each log.
2. Place pins on log #1 into holes in rear
bracket as shown in Figures 14 and 15.
3. Place pins on log #2 into slots in middle
bracket as shown in Figures 14 and 15.
4. Place pins on log #4 into holes to the left
of the burner as shown in Figure 14 and
Figure 16, page 17.
5. Place pins on log #8 into holes to the right
of the burner as shown in Figure 14 and
Figure 16, page 17.
16
INSTALLATION

INSTALLING LOGS

6. Place pin on log #5 into hole in the left side
of log #1 as shown in Figures 16 and 17,
page 17.
7. Place log #6 into cutouts in log #1 and log
#2 as shown in Figure 17, page 17.
8. Place pin on log #7 into hole in the right side
of log #1 as shown in Figures 16 and 17,
page 17.
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Holes for
Log #4
Figure 14 - Log Base and Chassis
www.usaprocom.com
Slots for
Holes for
Log #2
Log #1
Holes for Log #3
Log #2
Figure 15 - Log #1, #2 and #3
Holes for
Log #8
Log #1
Log #3
200047-01A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pcsd25rtPcnsd25rtPcnsd25t

Table of Contents