Table of Contents
Advertisement
Install Batteries
Batteries are required in both the Remote
Control (Transmitter) (2 AAA size) and Re-
ceiver (4 AA size) (see Figure 20).
Note: Be sure batteries are placed correctly.
Reversing the batteries can cause damage to
the receiver and remote. Replace all batteries
on a yearly basis or sooner.
Receiver
Figure 20 - Installing Batteries in Remote
Control and Receiver
When matching security codes, be sure slide switch on the receiver is in the REMOTE posi-
tion. To program the remote receiver to LEARN a new security code, press and release the
LEARN button on the top of the remote receiver, and then press ON or OFF button on the
transmitter. A change in the beeping pattern at the receiver, indicates the transmitter's code
has been programmed into the receiver.
This appliance must not be used with glass
doors in the closed position. This can lead to
pilot outages and severe sooting outside the
fireplace.
The remote operates on 2 AAA batteries.
Key Settings
ON - Operates unit to on position, manually
operated solenoid ON.
OFF - Operates unit to off position, manually
operated solenoid OFF.
MODE - Changes unit from manual mode to
thermo mode.
SET - Sets temperature in thermo mode.
200047-01A
OPERATION
REMOTE CONTROL SYSTEM
Remote Control
(Transmitter)
Matching Security Codes
REMOTE CONTROL OPERATION
www.usaprocom.com
Programming the Remote and Receiver
The remote and receiver must be "learned"
to one another.
1. Turn control knob on the heater to the ON
position.
2. Place the slide switch on the receiver in
the remote position (see Figure 21).
3. Use a pen or small screwdriver to gently
press and release the recessed LEARN
button on the face of the receiver. You will
hear a beep.
4. Press the ON button on the remote (see
Figure 22). You will hear a series of beeps.
Your appliance should come on.
Learn Button
LEARN
ON
Figure 21 - Receiver
Figure 22 - Remote Control
Slide Switch
REMOTE
OFF
TEMP
21
Hide quick links:
Advertisement
Table of Contents
