The Windows Client Ap Connection Screen - ATEN KH1508Ai User Manual

The Windows Client AP Connection Screen

A description of the Connection Screen is given in the following table:
Item
Server List
Server
Message List
Switch to Remote View Once you have been authenticated (see Connecting –
Each time the WinClient.exe file is run, it searches the user's
local LAN segment for KH1508
whichever ones it finds in this box. If you want to connect to
one of these units, double-click it. (See Connecting –
Windows Client AP, page 54 for details.)
Note: 1. The switch will not appear in the list unless its
Enable Device List configuration parameter has
been enabled.
2. Only units whose Access Port settings for Program
match the number specified for Port in the Server
area of this dialog box appear in the Server List
window.
This area is used when you want to connect to a KH1508
KH1516 i at a remote location. You can drop down the IP list
A
box and select an address from the list. If the address you
want isn't listed, you can key in the target IP address in the IP
field, and its port number in the Port field. (If you don't know
the port number, contact your Administrator.)
When the IP address and Port number have been
specified, click Connect. (See Connecting – Windows
Client AP, page 54 for details.)
When you have finished with your session and come back
to this dialog box, click Disconnect to end the connection.
Located just to the right of the Server panel, the Message List
panel lists status messages regarding the connection to the
KH1508 i / KH1516
A A
Windows Client AP, page 54 for details), this button becomes
active. Click it to switch to the GUI Main Page. The GUI Main
Page is described on page 59.
Chapter 5. Logging In
Description
i / KH1516
A
i.
i, and lists
A
i /
A
53