Step 8, Adjust Door Swing; Step 9, Install Grille Panel - Monogram WX08X10002 Design And Installation Manual

STEP 8 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° position.
Remove wire cover
trim screws
• Reinstall the wire cover trim.
729Dia79
Installation Instructions
13
STEP 9 INSTALL GRILLE PANEL
• Raise the grille panel to stop position.
Loosen
Side
Trim
Screw
• Loose screws on side trim behind frame. Remove
bottom trim.
194Dia25
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
Raise Grill Panel
Adjust Nut Below Spring to
Accommodate Panel Weight
Loosen
Side
Trim
Screw