Related Manuals for Monogram WX08X10002
Summary of Contents for Monogram WX08X10002
- Page 1 Installation Instructions Stainless Steel Free-Standing, Drawer Freezer Refrigerator 31-46547 225D1974P007 monogram.com...
-
Page 2: Table Of Contents
• Les réparations doivent être faites par un technicien covered under the GE Appliance Warranty. qualifié. See the Owner’s Manual for warranty information. For Monogram local service in your area, call 1.800.444.1845. For Monogram service in Canada, call 1.800.561.3344 For Monogram Parts and Accessories, call 1.800.626.2002. -
Page 3: Product Dimensions And Clearances
Depth Including Handles 29-1/2" - Tubular Handles 30-1/4" - Professional Handles These Monogram free-standing refrigerators require the Installation in a corner: following clearances for proper air circulation, plumbing • Allow 4" clearance on each side to an adjacent wall for a and electrical connections. -
Page 4: Installation Instructions
Installation Instructions TOOLS REQUIRED FLOORING • Adjustable wrench For proper installation, this refrigerator must be placed on • 3/8" and 5/15" socket ratchet/driver a level surface of hard material that is at the same height • Phillips head screwdriver as the rest of the flooring. This surface should be strong •... -
Page 5: Step 1 Measure Cabinet Opening
Installation Instructions WARNING STEP 2 LOCATE ANTI-TIP BRACKET A. Place the anti-tip floor bracket locator template (included inside the anti-tip kit) onto the floor up against the rear wall, within W, and in line with the desired location of the RH side of the refrigerator (see Figure 1). -
Page 6: Step 2, Install Anti-Tip Bracket
Installation Instructions STEP 2A LOCATE ANTI-TIP FLOOR STEP 2B INSTALL ANTI-TIP BRACKET BRACKET (CONT.) (CONT.) CONCRETE Wall and Floor Construction: Figure 2 – Acceptable Screw Placement Locations A. Anchors required (not provided): 4 each 1/4” x 1 1/2” lag bolts Preferred Installation –... -
Page 7: Step 3 Install The Refrigerator
Installation Instructions STEP 3 INSTALL THE REFRIGERATOR STEP 4 REMOVE THE FREEZER DRAWERS BEFORE MOVING REFRIGERATOR The freezer drawers can be removed, if needed, INDOORS to fit through tight areas. Read these instructions completely and carefully. IMPORTANT: TOP DRAWER Doors and passageways into the installation location require a 31"... -
Page 8: Step 5 Remove The Fresh Food Doors
Installation Instructions STEP 4 REMOVE THE FREEZER STEP 5 REMOVE THE FRESH DRAWERS (CONT.) FOOD DOORS BOTTOM DRAWER The top cap must be removed to access hinges. It is best to remove one door at a time. REMOVE THE 2-PIECE BASKET A. -
Page 9: Step 6 Remove The Toekick
Installation Instructions STEP 6 REMOVE THE TOEKICK STEP 8 REPLACE THE FREEZER DRAWERS (CONT.) If, after removing the freezer drawers and refrigerator door, the refrigerator will still Drive the bottom outside screw into the door not fit through a doorway, the toekick on each side until it is all the way in. -
Page 10: Step 8, Replace The Freezer Drawers
Installation Instructions STEP 8 REPLACE THE FREEZER STEP 8 REPLACE THE FREEZER DRAWERS (CONT.) DRAWERS (CONT.) BOTTOM DRAWER REPLACE THE 2-PIECE BASKET: ATTACH AND SECURE THE BOTTOM DRAWER TO THE SLIDES Place the rear of the basket onto the metal slide brackets. There will be 2 pins on each underside of the back that will Pull out the rail assemblies to the full align for securing the basket. -
Page 11: Step 9 Replace Fresh Food Doors
While holding the aligned door 2' (0.6 m) – WX08X10002 in place, tighten the top hinge bolts. 6' (1.8 m) – WX08X10006 15' (4.6 m) -
Page 12: Step 10A, Ro Water Line
Installation Instructions STEP 10A WATER LINE STEP 11 CONNECT WATER SUPPLY INSTALLATION WITH Check to be sure that refrigerator power cord is not A REVERSE OSMOSIS plugged into the wall outlet. SYSTEM 1/4" T ubi ng T ubi ng Cl am p Skip this step when not using RO System. -
Page 13: Step 14, Level Refrigerator
Installation Instructions STEP 14 LEVEL THE REFRIGERATOR STEP 15 LEVEL THE DOORS Adjust the Rollers If the doors are not evenly aligned at the top, the refrigerator door can be adjusted. The refrigerator can be leveled by adjusting the rollers, •... -
Page 14: Step 16 Install Toekick
Installation Instructions STEP 16 INSTALL TOEKICK STEP 18 TEMPERATURE CONTROLS • Press toekick into position and reinstall one screw on • The temperature controls are preset at 37°F each side. for the refrigerator and 0°F for the freezer. • Allow 24 hours to stabilize before making adjustments. Toekick Screw IMPORTANT: The vented toekick must... - Page 15 Notes...
- Page 16 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram local service in your area, call ® 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.