Step 14, Install Toekick - Monogram WX08X10002 Design And Installation Manual

STEP 14 INSTALL TOEKICK
• Locate the supplied toekick (shipped taped to
the side of the refrigerator). Install the toekick
assembly with the 3 screws provided, adjust to the
desired height and tighten the screws.
• A custom toekick can be installed to match or
complement the surrounding cabinetry. Use the
supplied toekick as a template to cut the shape.
IMPORTANT: The gap between the bottom of the
refrigerator cabinet and the top of the toekick must
remain unobstructed for proper air circulation.
Installation Instructions
17
INSPECT FINAL INSTALLATION
Check door alignment
Stand back away from the refrigerator to inspect the
final installation.
• Installation or the addition of heavy door panels
may have caused the doors to move slightly out of
alignment. Check to be sure the top of the doors are
evenly aligned with each other. If necessary, the doors
may be adjusted up or down to align.
• Add or subtract shims as shown to adjust the right
door only. More shims are located under the hood on
the left side in the bag with the filter bypass plug and
mini manual.
To Raise Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Snap a shim onto the hinge pin below the bushing.
• Lower the door and re-check the alignment.
• Repeat as necessary.
To Lower Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Remove a shim by pushing shim off of the hinge pin.
• Lower the door and re-check the alignment.
• Repeat as necessary.
Bag location
Shim