Master And Slave Operators Without Timer - Elite Robo Slide Instruction Manual

M A S T E R
To use the master/slave option with Robo Slide, you must purchase the Optional Input
Board (Elite Part # Q203) and connect it to the J2 slot.
Caution: 18 VAC plug-in transformer, per gate operator required
Master
Master J2 Plug
1. Make master/slave J2 plug connections as shown above
2. Turn timers on BOTH control boards to the "OFF" position
Master Timer "OFF"
A N D S L A V E
2 Low Voltage Wires Connect Gate Operators Together
Master Pin 1 to Slave Pin 1
Master Pin 2 to Slave Pin 2
W I T H O U T
Refer to Optional Input Board
Slave Timer "OFF"
T I M E R
Slave
Slave J2 Plug