Step 8: Adjusting Gate Travel Distance; Step 9: Timer - Elite Robo Slide Instruction Manual

S T E P

STEP 8: Adjusting Gate Travel Distance

Adjustment is done by limit switches which are located on the Robo Slide chassis. By
pressing the plate down and spinning the adjustment nuts, set your limit switches for open
and close cycles.

STEP 9: Timer

If you want to use the automatic close for the gate system the timer switch should be put in
the "ON" position. If you want to use the push open or push close command, the timer
should be switched to the
Set Timer
1 to 60 seconds
B Y S T E P
Limit Switches
"OFF" position.
I N S T A L L A T I O N
Each notch of the nut indicates an
estimated 1 inch of gate travel