Table of Contents
Advertisement
and Austria. Information
concerning
the application,
cpera-
ticn or service of your instrument may be directed fc the ap-
plications engineer at any of these locations. Check the inside
front cover of this manual for addresses.
1.6 MANUAL
ADDENDA
Information
concerning
improvements
or changes to the in-
strument which occur after the printing of this manual will be
found on an addendum sheet included with this manual. Be
sure to review these changes before attempting to operate or
service the instrument.
1.7 SAFETY SYMBOLS
AND TERMS
The following
safety symbols and terms are used in this
manual or found on the Model 485.
The symbol
A
on the instrument
indicates that the user
should refer to the operating instructions
in this manual.
The WARNING
heading in this manuel explains dangers that
could result in personal injury or death.
The CAUTION
heading in this manual explains hazards that
could damage the instrument.
1.8 OPTIONAL
ACCESSORIES
The following
accessories can be used with the Model 485.
Model
1010 Single
Reck Mounting
Kit-Use
to mount
one Model 485 in e standard 5% x 19" rack.
Model 1017 Dual Reck Mounting
Kit-Use
to mount two
Model 486's in a standard 5% x 18" rack.
Model 1684 Hard Shell Carrying
Case-Hard
vinyl case,
IOOmm x 300mm x 350mm (4 x 13 x 14 inches) has a fit-
ted foam insert with room for the Model 485, instruction
manual end small accessories.
Model
1768 Rechargaable
Battery
Pack-Provides
six
hours minimum operation from full charge, recharges within
10 hours end is field installable.
Model
4801 Input Cable-A
low noise coaxial cable four
feet (1.2m) in length with a male BNC connector
on each
end.
Model
4803 Low Noise Cable Kit-Consists
of 50 feet
(15.2m) of low noise coaxial cable, 10 male BNC connectors,
and five female chassis mount BNC connectors.
Model 4863 IEEE-486 Interface-Field
installable prcgram-
mable
option
provides
isolated
data
output.
Switch-
selectable talk only or addressable modes. Mounts within and
powered by the Model 485.
Model
7008 IEEE-488 Digital
Cable-Useful
for ccnnect-
ing the Model 4853 to the IEEE-488 bus. The Model 7008-3 is
0.9m 13 ft) in length and has a standard IEEE-488 connector
at each end. The Model 7008-6 is 1.8m (6 ft) in length.
Modal
8673 IEEE-486
Interface
for IBM
PC-Field
in-
stallable programmable
option provides data output for the
IBM PC. Mounts within and powered by the IBM PC.
l-2
Advertisement
Table of Contents
