Sound Authoring; Copy User Bank To Flash - E-Mu Proteus 1000 Operation Manual

Sound
Authoring
Copy User Bank
to Flash
_ _ _ _
If there is no Flash SIMM
in the unit, the error message,
"Requires Flash SIMM" will be
displayed.
160 E-MU Systems
This is a special purpose function to be used with the Flash sound
authoring feature. Flash Sound SIMMs created on an EOS Ultra sampler can
be used as a custom Proteus 1000 bank. Presets are then created in a User
bank. When the bank of presets is finished, it can be copied, using this
function, to the Flash SIMM. Flash SIMMs contain two separate memory
locations. One of these memories contains the sound samples and the
other memory can hold four banks of 128 presets.
WARNING: dangerous voltages are exposed inside Proteus 1000! Make
sure power is completely disconnected from Proteus 1000 before removing
the top panel. Replace the top panel before restoring power to the unit. The
two sound SIMM sockets in Proteus 1000, marked 0 and 1, are located
behind the controller knobs on the circuit board.The destination Flash
SIMM must be placed in SIMM socket 1.

COPY USER BANK TO FLASH

From: User
To Copy a User Bank to Flash
Make sure a Flash SIMM is inserted into the extra Proteus 1000 SIMM
1.
socket.
Press the Save/Copy menu button.
2.
Rotate the Data Entry Control to select the "Copy User Bank" function
3.
shown above.
Move the cursor to the "From" field and select the User bank that you
4.
want to copy to the Flash SIMM.
Move the cursor to the "To" field and select the Flash bank that you
5.
want to contain the User bank.
Press Enter. The Enter LED will flash and the screen below appears.
6.
Press ENTER to Overwrite
Flash SIMM Presets
Press Enter again to confirm. The following screen appears:
7.
COPYING USER BANK TO FLASH
Done. Please Reboot Now.
The Flash presets cannot be used until Proteus 1000 is rebooted (power
8.
off then on). Reboot the Proteus 1000 and verify that the new Flash
bank has been properly copied.
0
To: Flash
Save/Copy Menu

Sound Authoring

2