2.2 Setting the desired temperature
: "on/off" or stand-by
: display required water temperature or setting
: setting values
Starting up
the heat pump is in stand-by:
press 3 seconds on
appears for 5 seconds,
then the water temperature is displayed.
Stopping of the appliance
press 3 seconds on
appears
Adjusting the temperature
press on
and
Putting the setpoint on maximum will not heat the water any faster.
2.3 Regulator display
Display
heat pump stopped, waiting
Outside temperature too low
2.4 Adjusting the water flow
,
,
,
or
and
.
Status / cause
V1-V2-V3:
by-pass valves
: controller "on" indicator
: priority heating output enabled
indicator
: compressor "on" (steady) or
timed (blinking) indicator
: defrost in progress (steady) or
timed (blinking) indicator
Solution
wait for the filter to start up again, if the
message persists, contact your installer
Wait for the outside temperature to increase
naturally
V5-V4:
Setting valve
(optional)
3