Table of Contents
Advertisement
POSITION (fig. 13)
The appliance should be positioned in good light
and free from draughts. Any adjoining wall surface
situated within 200 mm from the edge of any hob
burner must be a suitable non-combustible material
for a height of 150 mm for the entire length of the hob.
Any combustible construction above the hotplate
must be at least 750 mm above the top of the burner
and no construction shall be within 450 mm above
the top of the burner.
Where a combustible surface adjacent to the cooker
is less than 200 mm from the nearest burner it may
be protected by a non-combustible protective layer
in accordance with AS5601. The protection must
ensure the surface temperature of the combustible
surface does not exceed 65º C above ambient.
LEVELLING THE COOKER
• Adjustable feet, to be fitted to the appliance, which
allow the height of the cooker to be aligned with
other kitchen furniture This can be done by means
of the terminal part of the leg themselves (fig. 14)
• Backguard. The cookers which are equipped
with this accessory, leave the factory with this part
inserted inside the packaging. In order to install the
backguard, it is necessary to loosen the screws (V)
positioned on the back of the hob and then to fix the
backgaurd as indicated in figure 15.
INSTRUCTIONS FOR THE INSTALLER
� �
� � �
�
13
14
�
15
OUTSIDE COOKER DIMENSIONS (Q)
D = 600 mm
h = 885 - 940 mm
W = 900 mm
H = 945 - 1000 mm
�
�
18
�����
�
�
�
Q
Hide quick links:
Advertisement
Table of Contents
