Setting The System Clock - JVC UX-J51 Instructions Manual

Setting the System Clock

Set the system clock to the correct time. If the system clock time setting is not correct, the Program Timer
will not start playback at the correct time.
* On step 3 and 4,
clock display shown
is diff erent for U.S.A.
and Canada.
60
1 1
Press the [MODE] key.
2 2
Select "TIME ADJUST".
Press the [C] or [D] key.
*3 *3
Set the day of the week.
Press the [A] or [B] key.
*4 *4
Set the time.
Use the [A] or [B] key to set the "hour".
Use the [A] or [B] key to set the "minute".
z
The currently set day of the week and time are displayed.
z
If you make a mistake, repeat the procedure from the beginning.
z
If there is a power failure or the system is unplugged from the wall
outlet for some time, set the time again.
z
Pressing the [F] key on the remote control while the system is in the
Standby mode will display the time for 5 seconds.
Press the [ENTER] key.
Press the [ENTER] key.
Press the [ENTER] key.
Press the [ENTER] key.