Resetting The Microcomputer - JVC UX-J51 Instructions Manual

Remote control
Symptoms
The remote control
does not work.

Resetting the microcomputer

Symptoms
Microcomputer
malfunction (the
system does not
work, the display is
faulty, etc.).
Solution
z
Load new batteries.
z
Use the remote control within its effective range.
z
Malfunctions may occur due to an external cause or because a
connection cord was unplugged while the system was turned on.
Use the procedure below to reset the microcomputer.
1 Unplug the power cord from the
AC wall outlet.
2 Plug the power cord back in while
holding down the power [
on the main unit.
3 Upon the start of the
microcomputer resetting, the
display shown on the right
appears.
z
During the resetting of
microcomputer, the display goes
out.
4 When fi nish resetting, it turns to
Standby Mode.
z
Bear in mind that resetting
erases any stored information
and restores the system's default
settings.
Solution
] key
Troubleshooting
Ref. page
15
15
67