Table of Contents
Advertisement
| CA-MXS5SSMBK
Using the Timers
Setting the Clock
The clock will be displayed even when the system is turned off. Pressing
the TUNING/TIMER/DIMMER button ( < or > ) will switch between two
brightness levels for the clock.
1.
Press the CLOCK ADJUST button on the Tuner.
The hours digits blink.
CLOCK ADJUST
=)
. Pressthe TUNING/TIMER/DIMMER button ( < or P )tosetthe hours
digit.
TUNING/TIMER/DIMMER
cr)
Press the > button to increase the hour, and press the < button to
decrease the hours.
To enter a new hour digit, press the CANCEL button and repeat step 2.
. Press the MEMORY button on the Tuner.
MEMORY
This sets the hour portion of the time.
The minutes digits will blink.
. Press the TUNING/TIMER/DIMMER
button (<orP) to set the
minutes digit.
It's a good idea to set the minutes digits one minute ahead. Then you
can start the clock when it reaches the set time exactly (according to the
correct time from the TV, radio, or telephone).
To enter a new minute digit, press the CANCEL button and repeat step
4,
. Press the MEMORY button.
The clock starts as soon as you press the MEMORY button.
Caution! If there is a power failure, or if you unplug the stereo, the clock
time will be lost. Repeat steps 1-5 when power is restored.
Using the TUNING/TIMER/DIMMER button to change luminosity of
time display by two steps under STANDBY status.
»
: Increases luminosity
: Decreases Juminosity
Setting the Timers
With the timers you can make tape recordings of broadcasts, CD's, or tapes
when you're not around. You can also play these music sources at
specified times without recording them.
Use TIMER 1 and TIMER 2 record a radio broadcast when you're not
home, or late at night when you're asleep.
Use the DAILY timer to record a broadcast that occurs at the same time
every day.
The procedure for setting TIMER 1, TIMER 2 and the DAILY timer is the
same. You need to tell the system:
— The name of the timer (TIMER 1 , TIMER 2, or DAILY).
— The time the timer should turn the system on.
— The time the timer should turn the system off.
-—— The source the timer should turn on (Tuner, CD, or Tape).
—— The volume level that should be used during recording or playback.
Note:
The clock must be set to the correct time for the timers to be effective.
Caution! Do not operate the remote controller when you are programming
the timer.
Choosing a Timer
Press the TIMER 1, TIMER 2, or DAILY button on.the Tuner to select a
Setting the Start Time
2. Press the MEMORY button.
This stores the hour portion of the start-time in memory.
MEMORY.
eS
4. Press the MEMORY button.
This stores the minute portion of the start-timer in memory.
Setting the Stop Time
2. Press the MEMORY button.
This stores the hour portion of the stop-time in memory.
4. Press the MEMORY button.
This stores the minute portion of the stop time in memory.
Selecting the Source
1. Press the TUNING/TIMER/DIMMER button to select a source.
order:
Display
What it meats
TUNER
Plays FM or AM broadcast
TUNER TIMER REC
Records FM or AM broadcast
cD
Plays a CD
TAPE
Plays a tape
Note:
2. Press the MEMORY button.
This stores the source to play or record in memory.
Setting the Volume
1. Press the TUNING/TIMER/DIMMER button to selecta volume level.
Display
What It means
VOL -~- 0
Volume off
VOL -~ A
Volume barely on
21
(No. 20342) 23
Advertisement
Table of Contents
