Prepare Installation - Prima LPR808 Users Manual And Installation Handbook

INSTALLATION INSTRUCTIONS
installation instructions - 90cm
Step 1: Prepare installation
Do not lift the appliance by the
step 1: Prepare installation
door handle.
Do not lift the appliance by the door handle.
Remove the fixing screws from the
polythene bag on the top of the Remove the fixing screws from the
polythene bag on the top of the appliance,
appliance, but leave the appliance in
but leave the appliance in the base tray
the base tray packaging until you are
packaging until you are ready to install it.
ready to install it.
Whilst every care is taken to eliminate
Whilst every care is taken to eliminate
burrs and raw edges from this appliance,
burrs and raw edges from this appliance,
please take care when handling - we
recommend the use of protective gloves
please take care when handling - we
during installation.
recommend the use of protective
gloves during installation.
Please note that the weight of this
appliance is approximately 48kg
Please note that the weight of this
(unpacked). Take care when lifting it
appliance is approximately 48kg
into the housing unit - always use an
(unpacked). Take care when lifting it
appropriate method of lifting.
into the housing unit - always use an
Note: When removing the appliance from
appropriate method of lifting.
the base tray packaging care should
be taken to ensure the appliance is not
Note: When removing the appliance
damaged.
from the base tray packaging care
siting the appliance
should be taken to ensure the appliance
is not damaged.
If this appliance is to be installed near to
a corner where the adjacent cabinets run
at right angles forward of the appliance,
Siting the appliance
there must be a gap of at least 90mm
between the appliance and the cabinets,
If this appliance is to be installed near
to prevent overheating of the cabinets.
to a corner where the adjacent
When installed in a typical 600mm
cabinets run at right angles forward of
deep built in housing unit, the false back
the appliance, there must be a gap of
should be removed from the housing
at least 90mm between the appliance
unit, to provide the necessary depth for
and the cabinets,
installation.
overheating of the cabinets.
When installed in a typical 600mm
deep built in housing unit, the false
back should be removed from the
housing unit, to provide the necessary
depth for installation.
When the false back is removed, it is
normally the case that the support shelf
When the false back is removed, it is
for the appliance leaves a gap
normally the case that the support shelf
between the back edge of the support
for the appliance leaves a gap between
shelf
the back edge of the support shelf and the
approximately 80mm.
rear wall of approximately 80mm.
If no gap occurs between the back
If no gap occurs between the back edge
edge of the shelf and the wall behind
of the shelf and the wall behind the unit,
you must create a gap of at least 30mm
the unit, you must create a gap of at
by shortening the shelf and any other shelf
least 30mm by shortening the shelf
below the appliance.
and any other shelf below the appliance.
Cut 12mm from the top of any plinth that
Cut 12mm from the top of any plinth
may be fitted (see diagram).
that may be fitted (see diagram).
Important: Do not modify the outer
Important: Do not modify the outer
panels of this appliance in any way.
panels of this appliance in any way.
to prevent
25
and the rear wall of