Prima LPR808 Users Manual And Installation Handbook page 19

i) When installed in a typical
installation instructions - 60cm
600mm deep built in housing unit,
the false back should be removed
from the housing unit to provide the
i) When installed in a typical 600mm
necessary depth for installation.
deep built in housing unit, the false
back should be removed from the
ii) When the false back is removed, it
housing unit to provide the necessary
is normally the case that the support
depth for installation.
shelf for the appliance leaves a
ii) When the false back is removed, it is
gap between the back edge and
normally the case that the support
the wall of approximately 80mm.
shelf for the appliance leaves a gap
between the back edge and the wall of
iii) If no gap occurs between the back
approximately 80mm.
edge of the shelf and the wall
iii) If no gap occurs between the back
behind the unit, we recommend
edge of the shelf and the wall behind
that a gap of at least 30mm is
the unit, we recommend that a gap of
made by shortening the shelf.
at least 30mm is made by shortening
iv) When installing the appliance the shelf.
below a worktop, there must be a
iv) When installing the appliance below a
minimum ventilation area of 60cm
worktop, there must be a minimum
ventilation area of 60cm2 below the
below the appliance, in either
appliance, in either area (1) or (2), as
area (1) or (2), as indicated below.
indicated below. There must be a
There must be a 5mm gap
5mm gap between the front top edge
between the front top edge of the
of the oven and the underside of the
oven and the underside of the worktop.
worktop.
minimum
ventilation
area 60 cm
Installation Instructions
2
5 mm
worktop
front
of oven
(1)
support shelf
2
(2)
24
Important: Do not modify the outer
panels of this appliance in any way.
Ensure that you route all mains
electrical cables and flexible tubing
Important: Do not modify the outer panels
of this appliance in any way.
well clear of any adjacent heat source,
such as an oven, grill or hob.
Ensure that you route all mains electrical
cables and flexible tubing well clear of any
Ensure that all pipe work is of the
adjacent heat source, such as an oven,
correct rating for both size and
grill or hob.
temperature.
Ensure that all pipe work is of the correct
rating for both size and temperature.
Installing the appliance under a
installing the appliance under a worktop
worktop
Where the appliance is installed under
Where the appliance is installed under
a worktop, with a hob installed above it,
the installation instructions for the hob
a worktop, with a hob installed above
must be read in conjunction with these
it, the installation instructions for the
instructions.
hob must be read in conjunction with
these instructions.
30 - 80
mm