Step 1: Prepare Installation - Prima LPR802 Manual

08 27224 00 - Prima 60G

Step 1: Prepare installation

Do not lift the appliance by the
door handle.
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective
gloves during installation.
Please note that the weight of this
appliance is approximately 31kg
(unpacked). Take care when lifting it
into the housing unit - always use an
appropriate method of lifting.
Remove the fixing screws from the
polythene bag on the top of the
appliance, but leave the appliance in
the base tray packaging until you are
ready to install it.
If this appliance is to be installed near
to a corner where the adjacent
cabinets run at right angles forward of
the appliance, there must be a gap of
at least 90 mm between the appliance
and the cabinets, to prevent overheating
of the cabinets.
585
mm
26/1/05 9:22 am Page 21
Installation Instructions
Housing dimensions
The appliance is designed to fit into a
standard 600mm wide housing unit
with minimum internal dimensions as
shown.
591mm is to the underside of the
worktop when the appliance is built
under, or to the underside of the panel
above, when the appliance is installed
into a tall housing unit.
19
90mm (minimum)
min
560mm