Sony BVM-14F5U Operation Manual page 43

300
SET UP menu list: Choose the menu for setting the desired items.
INPUT CONFIGURATION menu
REMOTE menu: Set the remote control functionality ÷ 340
PASSWORD menu
SYSTEM CONFIGURATION menu
ON SCREEN SET menu
ALIGNMENT menu
EXTEND MENU
340
REMOTE menu: Select the type of remote control.
REMOTE 2: Select whether or not parallel remote control will be used (ON or OFF).
REMOTE 2 CONFIG...: Set the pin assignments for the REMOTE2 (parallel remote control)
connector. ÷ 341
REMOTE 1 CONFIG...: Set the address and group number of the monitor controlled via the
REMOTE 1 (serial remote control) connector. ÷ 343
341
REMOTE 2 CONFIG: Select the REMOTE 2 connector pins for which you want to
change the function. The factory settings for each pin are given below. ÷ 342
1 PIN...: CH01
2 PIN...: CH02
3 PIN...: EXT SYNC
4 PIN...: MONO
5 PIN...: SAFE AREA
6 PIN...: unused
7 PIN...: unused
8 PIN...: TALLY
342
1-8 PIN (1/2): Assign a function to the selected pin.
CH: Select a channel number. Enter the desired channel number with the numeric keypad.
----: Set to unused.
UNDERSCAN: Set underscan on or off.
16:9: Set a 16:9 aspect ratio on or off.
H DELAY: Set the horizontal sync display on or off.
V DELAY: Set the vertical sync display on or off.
EXT SYNC: Set the synchronization to external sync signals enabled or disabled.
COMB: Set the comb filter on or off.
APERTURE: Set the correction of frequency characteristics enabled or disabled.
MONO: Set monochrome display on or off.
39