Sony BVM-14F5U Operation Manual page 12

Location and Function of Parts
5 MANUAL adjustment buttons and knobs
Each press of one of these buttons turns the button's
green LED on or off. When the corresponding button
is on (lit), you can rotate the knobs to adjust the
picture's contrast, brightness (black level), chroma,
and phase. These buttons are also used to enter
adjustment values from the menus.
You can use the CONTROL PRESET ADJ menu to
set preset values for each adjustment item.
For more information about the CONTROL PRESET ADJ
menu, See "Preset Adjustment of the Picture Level Control
Knobs —CONTROL PRESET ADJ Menu" on page 22.
Note
When using the composite SECAM, composite PAL
D, component or SDI (component or composite serial
digital interface) format, note the following.
•The signal phase cannot be adjusted.
•The phase and chroma of RGB signals cannot be
adjusted.
MANUAL
CONTRAST
BRIGHT
CHROMA
PHASE
8
CONTRAST adjustment
button and knob
BRIGHT adjustment
button and knob
CHROMA adjustment
button and knob
PHASE adjustment button
and knob
6 Menu operation buttons
MENU button: Press to display monitor
menus.
UP MENU
UP, DOWN buttons: Press to select
ENTER
DOWN
menu items and item settings.
ENTER button: Press to confirm
settings (the same function with the Ent
button of the numeric keypad 4).
For more information about using monitor menus, see
"Basic Menu Operations" on page 15.
7 POWER lamp
Lights when the POWER switch 2 is pressed to put
the BVM-14F5U/14F5E/14E5U/14E5E in standby
mode (see 8 STANDBY lamp) into operation mode.
Note
When the STANDBY lamp 8 is blinking, the monitor
cannot be put into operation mode (internal data
initialization is taking place). Wait until the
STANDBY lamp 8 is steadily lit.
8 STANDBY lamp
Lights when the monitor is in standby mode. The
monitor will be in standby mode under the following
conditions:
• The MAIN POWER switch (on the rear panel) is
turned on (the STANDBY lamp will blink for a few
moments after the switch is turned on).
• The BVM-14F5U/14F5E/14E5U/14E5E is changed
from operation mode to standby mode by external
control.
9 OVER LOAD lamp
Lights to warn of CRT overload.
0 SHIFT button
Each of the Function buttons !¡ has a Shift On
function as well as a Shift Off function. Press this
button to select Shift On or Shift Off functions.
Each time you press this button, its orange LED lights
(Shift On) or goes out (Shift Off).
Shift On: Use the function indicated on the right of
the Function button.
Shift Off: Use the function indicated on the left of
the Function button.