Sony BVM-14F5U Operation Manual page 39

311
COMPOSITE (xxCH): Select the format of a composite or Y/C signal.
Notes
• Even when selecting AUTO, also select the NTSC, PAL, or PAL-M format.
• If there is no input connector or decoder corresponding to a format, that format will not be
selectable (the cursor will skip over that entry).
• When the BKM-21D is attached, changing the signal format of a channel from SDI to
COMPOSITE AUTO may prevent proper display of the picture. In this case, set the format
to NTSC or PAL first, then change to AUTO.
• When inputting the PAL-M YC signal to a channel with the BKM-26M attached, setting the
signal format to YC AUTO may prevent proper display of the picture. Set the format to
PAL-M (S or D).
AUTO: The format of the input signal is detected and switched automatically.
NTSC: SETUP 7.5 or 0.
PAL: S (simple) or D (delay).
PAL-M: S (simple) or D (delay).
SECAM
2) It will take a few seconds to detect the format of an input signal when AUTO is selected. It is
recommended that a particular format be selected if it is determined.
312
COMPONENT (xxCH): Select the component signal format, or RGB.
YUV SMPTE/EBU-N10
YUV BETACAM: SETUP 7.5 or 0.
RGB
313
SDI (xxCH): Select the format of the serial digital signal.
AUTO: The format of the input signal is detected and switched automatically.
NTSC: SETUP 7.5 or 0
PAL: S (simpe) or D (delay)
4:2:2
1) • It will take a few seconds to detect the format of an input signal when AUTO is selected. It is
recommended that a particular format be selected if it is determined.
• If the serial digital signal is not properly displayed at SDI AUTO mode, re-enter the channel
number.
315
YC SEP (xxCH): Select a Y/C separation filter.
TRAP/BPF
2 LINES COMB
3 LINES COMB
320
SCREEN MODE (xxCH): Select the scan size.
4:3-NORM: Overscanned 4:3 aspect ratio.
4:3-UNDR: Underscanned 4:3 aspect ratio.
16:9-NORM: Overscanned 16:9 aspect ratio.
16:9-UNDR: Underscanned 16:9 aspect ratio.
2)
1)
35