Digital Still Camera Features
Camera Recording
Card Recording
Available mode:
CARD-CAMERA
You can take a still picture in the same way as
you do with a standard camera and record that
image on the card.
Power Zoom control
Media Selection switch
STILL button
1
Insert a card into the camcorder (see
page 13).
2
Remove the lens cap. Pull out the
viewfinder completely or open the LCD
monitor.
3
Set the Media Selection
switch to CARD.
4
Hold down the Lock button and set the
POWER switch to CAMERA.
• The picture from the lens now displays.
Number of shots taken/remaining
Lock button
AU T O
73
VL-AX1H-071-076
5
6
7
POWER switch
Notes:
• Recording under insufficient lighting may result
CARD
9 3 1
/
E C ON OMY
[ 1 1 5 2
]
• Recording under the light of a fluorescent,
• Set the SOUND menu item to "OFF" to turn off
Caution:
• Do not turn the power off while the S indicator
73
Adjust the Power Zoom control to frame
the subject as you desire.
• The zoom range is 1–22K in this mode.
Press the STILL button half-way down to
focus on the subject.
• The camcorder automatically focuses on
the subject. When it is set, you will hear
a sound and see T mark, then the
camcorder locks the focus.
Press the STILL button fully to begin
recording.
A U T O
• The S indicator flashes red while data
is being recorded on the card, and
returns to white when recording
completes.
• To record another image, release the
STILL button and make sure the picture
is not frozen in the monitor, then perform
steps 6 and 7.
in blurred images. It is recommended that you
use a tripod to record insufficiently illuminated
subjects.
mercury, or sodium lamp may cause flickering in
the image and, depending on the timing of the
shot, may result in changes to colour hue in the
image.
the focus locking sound.
is flashing in step 7.
01.11.1, 11:12 AM
CARD
9 3 1
/
E C ON OMY
[ 1 1 5 2
]
CARD
9 3 1
/
E C ON OMY
[ 1 1 5 2
]