Attaching And Removing The Battery Pack - Sharp ViewCam Slim VL-AX1H Operation Manual

Attaching and Removing
the Battery Pack
Attaching
1
Make sure that the POWER switch is set
to OFF.
2
Pull out the viewfinder completely (1),
then lift it up (2).
60˚
3
Align the = mark on the side of the
battery pack with the = mark on the
camcorder (1). Press the battery pack
and slide it down completely until it locks
into place (2).
4
Lower the viewfinder (1), and push it in
completely (2).
VL-AX1H-009-021
Removing
1
2
POWER switch
Cautions:
• BEFORE REMOVING THE BATTERY PACK,
• Remove the battery pack from the camcorder if
• Make sure that the battery pack is firmly
• To prevent damage to the battery pack when
• Use only SHARP model BT-L221, BT-L441, BT-
10
Make sure that the POWER switch is set
to OFF.
Press and hold the power source
UNLOCK release in the direction of the
arrow (1), then slide the battery pack
up and take it out (2).
Power source
UNLOCK release
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF. Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum or destroy the card,
rendering it unreadable and unwritable.
you will not use the camcorder for a long period
of time.
attached during operation. If it is not, the battery
pack may come off or camcorder operation may
fall because of the poor contact pressure.
removing, be sure to firmly hold the battery pack
while pressing the release.
LS222 or BT-LS442A battery packs with this
camcorder. Use of other batteries may create a
risk of fire or explosion.
01.11.1, 11:00 AM
10