Table of Contents
Advertisement
Use
• To conserve battery power, be sure to turn off
the camcorder power when not in use.
• Battery consumption may vary depending on
the condition of use. Recording with many
starts and stops, frequent zooming, and
recording in low temperatures will shorten
actual recording times.
• Use of a weak battery pack may cause loss
of power while operating the camcorder. Use
a fully charged battery pack to protect both
the battery pack and the unit.
• It is recommended that you have enough
battery packs on hand to handle two or three
times your estimated recording time. See
page 23 for the approximate times of actual
recording for the battery packs.
Battery power is consumed even when the
camcorder power is turned off. If you are not
going to use your camcorder immediately,
remove the battery pack (see page 10).
Note:
• Use only SHARP BT-L221, BT-L441, BT-LS222 or
BT-LS442A battery packs. These are designed
specifically for use with this camcorder.
Extending battery pack life
Even when the battery pack is not used, the
capacity of the battery pack will naturally
deteriorate over time. To limit the deterioration of
the capacity, it is recommended to perform the
following procedure at least once every six
months:
1 Charge the battery pack until the CHARGE
indicator of the charger turns off.
2 Attach the battery pack to the camcorder, and
set the POWER switch to CAMERA without
inserting a cassette. Allow the battery power to
fully discharge by leaving it on the camcorder
until the camcorder power automatically turns
off.
3 Remove the battery pack and store it between
10°C and 20°C.
VL-AX1H-097-103
Storage
• Store the battery pack in a fully discharged
state.
• Store the battery pack in a dry, cool place.
• When storing a fully charged battery pack,
put the cover on it so that the "CHARGE"
mark printed on the label is seen through the
window, as shown.
Cover
When storing a battery pack that is not fully
charged, put the cover upside down so that
only the battery pack casing can be seen
through the window.
Cautions:
• Improper handling of the battery pack may
present a risk of fire or explosion. Pay close
attention to the following:
— Do not allow metallic objects to come in
contact with the terminals. This can cause a
short circuit.
— Do not disassemble or repair the battery pack
by yourself.
— Do not use any battery charging equipment
other than that designed for use with these
battery packs.
— Do not place the battery pack under direct
sunlight or in excessively hot places (over
60°C) such as the dashboard of cars.
— Do not expose the battery pack to moisture or
water.
— Do not drop the battery pack or subject it to
strong force.
— Keep the battery pack out of reach of
children.
— Dispose of used battery packs promptly. Do
not dispose of them in fire.
• To protect the terminals, put the cover on the
battery pack when it is not in use.
Notes:
• The battery pack will become warm during
charging and use. This is not a malfunction.
• The battery pack has a limited service life. If the
period of use becomes noticeably shorter with a
normal charge, the battery pack is at the end of
its service life. Replace it with a new battery pack.
• If the terminals of the battery pack are dirty, wipe
the terminals with a soft, dry cloth.
98
Battery pack
Label
CHARGE
Window
01.11.1, 11:17 AM
98
Advertisement
Table of Contents
