–
If the card function setting page appears, specify the necessary set-
tings.
6
Exit Web Connection.
Then, proceed with the user registration.
Registering a user
Register a user using Data Administrator. The following two methods can be
used.
Connect the authentication device to your computer, and use Data Admin-
istrator to register the target user and card at a time.
Connect the authentication device to this machine, and associate the
user, who has been registered using Data Administrator, with an IC card.
Registering a user using Data Administrator
To use Data Administrator, configure this machine, and set up Data Adminis-
trator. For setup, install the IC Card Driver (USB-Driver) of the authentication
device, and then install Data Administrator IC Card Plugin.
Before setup, install Data Administrator V4.0 or later in your computer.
For the Data Administrator operating environment and installation pro-
cedure, refer to the Data Administrator User's Guide.
Checking the version of the installed Data Administrator
1
From the [Help] menu of Data Administrator, select [Version Information].
This software cannot be used if the version is "3.x". Install "4.x".
If Data Administrator V3.x is installed, it is removed when V4.x is
installed.
2
Click [Plug-in version].
3
In [Plug-in information list], confirm the plugin version of Data Administra-
tor.
–
This software is available if the plugin version is "4.x".
Setup
1
Turn the Main Power Switch of this machine off, and disconnect the
authentication device from this machine.
Registering a user
15-3