Cleaning, Maintenance And Troubleshooting - Titan SF75 Safety And Operating Manual

5. FITTING AND USING THE EXTENSION
NOZZLE (see fig9)
(a) The extension nozzle should be used to
spray ceiling and floor. It should also be used in
areas with limited access.
(b) To remove the nozzle, unscrew the nozzle
and remove from the cylinder, make sure that
the valve remains in the cylinder.
(c) Screw the extension nozzle securely on the
cylinder, turn the spraying tube into the required
position.
Fig 9
(d) Hold the machine straight up during the
operation.
CLEANING, MAINTENANCE AND
TROUBLESHOOTING
Note: Do not clean the parts by holding
the machine in flowing water. Never clean
the parts by submerging the machine in
water or thinner.
Always remember to disconnect the plug from
the socket before cleaning the spray gun or paint
container, it is essential that the spray gun is
cleaned thoroughly after every use. Failure to
clean it will almost certainly result in blockages
and it may not operate when you next come to
use it !
THE FOLLOWING ACTION MUST BE TAKEN
AFTER EVERY USE
1. Remove the container and pour the remaining
liquid back in the can.
2. Clean the container thoroughly using paint
thinner.
3. Put some suitable thinner into the container
and be sprayed through the spray gun until only
clean thinner comes out of the nozzle.
4. Remove the container, the suction tube and
the filter.
5. Thoroughly clean the container, the suction
tube and filter with thinner.
6. Loosen the nozzle slightly, unscrew the
locknut and pull the nozzle and piston assembly
out of the unit.
7. Move the nozzle and locknut from the cylinder,
take the valve out of the cylinder.
8. Clean the nozzle, valve, locknut, cylinder,
piston spring and piston thoroughly with