Spraying Techniques - Titan SF75 Safety And Operating Manual

4. SPRAYING TECHNIQUES (see fig5,fig6,fig7
and fig8)
To obtain the best results, keep your spray gun
level and parallel to the surface at all times. Keep
the nozzle 25~35cm from the surface and spray
evenly from side to side or up and down, use
smooth and even strokes (see fig5).
Do not spray at an angle because this will lead
to paint runs on the surface (see fig6 and fig7).
When spraying large areas use a crisscross
pattern as shown (see fig8)
Move the spray gun evenly from the arm ,not
from the wrist. Never start or stop the spray
gun while it is aimed at the surface to be
sprayed. Evenly control the speed of movement
of the spray gun. A fast speed of movement
over the surface will give a thin coat and a
slow speed will give a heavy coat. If a further
coat is required, make sure you observe the
manufacturers drying time recommendations
before applying second coat. To avoid using
too much paint and prevent overspray. Where
possible, avoid stopping and starting when
spraying an object. This can lead to too much, or
not enough paint being applied. Do not tip the
spray gun to more than 45
80W SPRAY GUN
o
.
Fig 5
Fig 6
Fig 7
Fig 8
SF75