Band Edge Beeper - Yaesu FT-1907R Operating Manual

The FT-1907R will automatically "beep" when the receiver's band edge is encountered
during scanning (either in standard VFO scanning or during PMS operation). You may
additionally enable this feature (band edge beeper) when the frequency reaches the band
edge while selecting the VFO frequency manually, using the DIAL knob.
The procedure for enabling the Band-Edge Beeper (during manual tuning) is:
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "21 EDG.BEP."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to
set this Menu item to "ON."
3. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit
to normal operation.
FT-1907R O
PERATING
B E
AND DGE
M
ANUAL
S
B
EEPER
CANNING
49