Ctcss/Dcs/Epcs Bell Paging - Yaesu FT-1907R Operating Manual

CTCSS/DCS/EPCS O
CTCSS/DCS/EPCS B
During CTCSS Decode, DCS, or EPCS operation, you may set up the FT-1907R such that
a ringing "bell" sound alerts you to the fact that a call is coming in. Here is the procedure for
activating the CTCSS/DCS/EPCS Bell:
1. Set the transceiver up for CTCSS Decode ("Tone Squelch"), DCS, or EPCS operation,
as described previously.
2. Adjust the operating frequency to the desired channel.
3. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "7 BELL."
4. Rotate the DIAL knob to set the desired number of rings of the Bell. The available
choices are 1, 3, 5, or 8 rings, CNTNUE (continuous ring-
ing), or OFF.
5. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit
to normal operation.
When you are called by a station whose transceiver is sending a CTCSS tone, DCS code, or
CTCSS code pair which matches that set into your Decoder, the Bell will ring in accor-
dance with this programming.
When the CTCSS/DCS/EPCS Bell is activated, the " " icon
will appear on the display.
28
PERATION
O
ELL PERATION
FT-1907R O
PERATING
M
ANUAL