Cw Training Feature - Yaesu FT-1907R Operating Manual

CW T
RAINING
The FT-1907R provides a CW Training feature, which sends random Morse Code via the
sidetone (heard in the speaker), so you can improve your CW proficiency.
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "12 CWTRNG."
2. Press the [ MHz ( SET )] key momentarily to enable adjust-
ment of this Set Mode Item.
3. Press the [ LOW ( A/N )] key to select the Training mode (displayed in fine print at the
upper edge of the LCD):
1A
: Sends five Alphabet characters only
A
: Sends Alphabet characters only (Repeatedly)
1n
: Sends five Numeric characters only
n
: Sends Numeric characters only (Repeatedly)
1An
:Sends five Alphabet, Numeric, "?," and "/" characters (Mixed)
An
: Send Alphabet, Numeric, "?," and "/" characters (Mixed, Continuously in group
of five)
4. Rotate the DIAL knob to select the Morse speed. You may select the units of the code
speed between "WPM (Words per minute)" and "CPM:
characters per minute)" by pressing the [ D/MR ( MW )] key.
5. Press the [ REV ( DW )] key to begin generation of the code characters (CW sidetone
only, the radio does not transmit); the transmitted charac-
ters will appear on the display. If one of the "
selected in step 3 above, press the [ REV ( DW )] key to send another code group.
6. To disable the CW Training feature, press the [ MHz ( SET )] key momentarily.
7. Press and hold in the [ MHz ( SET )] key for one second to exit to normal operation.
The "CPM" selection is based on the international "PARIS" standard, which
stipulates five characters per word.
58
F
EATURE
1
" modes is
FT-1907R O
PERATING
M
ANUAL