FUNAI ZV427FX4 Owner's Manual page 86

Symptom
The disc tray does not open when you
press [A].
"Repairing" appears on the TV screen.
Repairing
In a case you intend to cancel the
repairing process.
Do you want to cancel a repairing
process? When selecting "Yes",
the disc may not be usable.
Yes
No
Repairing
Picture noise appears.
The cassette tape does not play back.
Recording does not start after you press
[REC].
The remote control does not function. • Check if a cassette tape is in this unit.
The motor rotates even when
playback / recording is stopped.
86 EN
TROUBLESHOOTING
Remedy
• It may take a few seconds for the disc tray to open after you have
recorded or edited a disc. This is because the unit is adding disc data to
the disc.
formatting or editing (even after "Repairing" disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
• If you intend to cancel the repairing process, press [A] on the front
panel, then select "Yes" and press [OK]. After that, press [A] to take out
the disc. The disc cancelled during the repairing process MAY NOT
work.
• Head cleaning for VCR may be necessary. Refer to "Auto head cleaning"
(page 4).
• Adjust tracking control for better picture by pressing [TRACKING K / L]
while you are playing back a cassette tape.
• No cassette tape is inserted.
• Make sure the cassette tape has an erase-protection tab when you
record to a cassette tape. If needed, cover the hole with cellophane
tape.
• The motor may rotate for the duration of approximately 5 minutes for
efficient operation. This is not a malfunction.
Instructions continue on the next page.