Heartway Medical Products PF2 User Manual page 19

Plug the XLR connector of the charger to the charger port.(See Fig 24)
Plug the other end of power cord into a standard wall outlet.
When charging is completed, battery capacity indicator is shown.
Disconnect the charger power cord from the wall outlet when the batteries are
fully charged.
Charger
Port Door
Important!
Make sure voltage input is correctly selected for your location (110V or 220V)
and adjust manually. (See Fig 25)
plug-in controller plug-in wall outlet
(Fig 24)
*. Recharge battery only when the key is in off position. When indicator is
showing low status, this confirms battery needs recharge.
Note:
Always charge your batteries in well ventilated areas.
The charger is intended for indoor use only. Protect from moisture.
For maximum performance , it is recommended that you replace both
batteries at the same time if the batteries are weak.
If the vehicle will not be used for a long period of time, arrange to have the
batteries recharged at least once every month to avoid deterioration of the
batteries..
(Fig 25)
(Fig 23)
19