Installation Menu; Antenna Setting - Televes RSD - 711801 User Manual

User Manual

10.- Installation Menu

10.1.- Antenna Setup
This menu enables you to configure the receiver according to your installa-
tion.
Access the Antenna Setup menu by pressing the OK button on the option
"Installation" in the main menu.
The CH /CH buttons enable you to move the cursor up and down
within the menu, while the V+/V- buttons enable you to select from among
the available options.
Satellite
Select one of the satellites that are pre-programmed on the receiver
using the V+/V- buttons, or pressing the OK button to activate the
popup menu and thus easily select the satellite.
By pressing button 1, you activate a keyboard where you can change
the name of the selected satellite.
By pressing button 2, you can enter a new satellite, and here you must
enter all the necessary data for its correct functioning, as indicated in
the following steps.
By pressing button 3 you will erase the satellite selected. Here you will
have to confirm the decision to erase.
Satellite Longitude
Introduce the satellite longitude in degrees (3 digits) using the numerical
keyboard. With the V+/V- buttons you can indicate if the position is East
or West.
LNB Type
Indicate if the LNB placed on the aerial is "Universal", "Unicable",
"C-band" or "User", using the V+/V- buttons.
You can also edit the LNB frequency by pressing the OK button on this
option. In the popup menu, with the V+/V- buttons, we can select other
values for LNB frequency.
22KHz
To enable or disable the 22KHz tone. If you have selected a Universal
LNB in the previous operation, this option will not be available.
DiSEqC
Select one of the options: "Disable", "A", "B", "C" or "D". To do so,
press the OK button to activate the popup menu, and thus select the
correct input.
If you are selecting one of the inputs, the "Positioner" option will not be
available.
With the "Tone Burst" option enabled, the inputs to be selected will be
"A" and "B".
23
"RSD - 711801"